Ford Think Programming, Ford Think Owners, D1 controller, D1 controller, GE controller D1, Sentry Software, GE Sentry, Ford Think Diagnostics

Ford Think  Diagnostics and Programming Kit
For the 354D1 Controller



If you have the GE IC3645SH7R354D1 Controller
You can Now Program or Diagnose Failures Using GE Sentry Software.
These Controls are Generally Used on the older Think Models



This Type of Controller Does Not Have the Ability to Communicate via the Data Port
So a Special Programming Interface Cable is Necessary to Communicate.
Not sure which Controller you Have?
Click Here




Click To Enlarge

Kit Includes everything you need:

Service CD Includes:

• GE Sentry Software 4.07
• GE Operating and Maintenance Manual for your 354D1 Traction Control
• 10 Page Detailed Hookup/Programming  Instructions
• D1 Data Base File for Proper Function/Setting Definitions

The Complete Kit Also Includes:

• Special Programming Interface Cable
• 6 Foot Shielded DB9 Extension Cable

The GE Manual includes:

• Complete Theory Of Operation
• Elementary Wiring Diagrams
• 23 Pin Main Plug Function Listing
• Troubleshooting and Diagnostic Help
• Status (Fault) Code Explainations
• Complete Function Settings Guide

What Can I do with GE Sentry Software?

• Read, Print and Save Your original Settings
• Change and Download New Settings
• Access 16 Stored Fault Codes

NOTE: Due to the special Cable used with this Kit, Monitoring and Graphing Features will not be available



 
The Interface cable connects to your Laptop or PC and to the 23 Pin Main Plug on your 354D1 Controller (Controller shown is not the D1)
The Detailed Instructions take you step by step through the Software Setup.


Click To Enlarge



DB9 Serial Port Computer Connector

Click to Enlarge

PLEASE NOTE: This cable is a 9 Pin DB9 Serial Port Cable. Make sure your computer you plan to use has a True Serial Port.
The Serial Port on your computer will have 9 Male Pins, do not confuse this with the monitor connector.
I have used USB to Serial Converters, some work some don't, I have had good success with the
Sabrent Cable   Make sure any you try has over 230kbps Data Transfer Rate.
.

 
We have been supplying Programming Kits for Electric Forklifts using GE Sentry Software since it was first a DOS program.
We are fully authorized by GE to distribute this software and it comes direct from GE.
See our other Kits here:  Forklift Electronics Store



Purchase the Complete Kit Using PayPal's Secure Site
 

 

 

If You have the T3 Series Control without a Data Port Plug, There is a Dedicated Kit For your Controller:
T3 Diagnostic and Programming Kit

If You have the T2 Series Control with a 12 Pin Data Port Plug, There is a Dedicated Kit For your Controller:
T2 Diagnostic and Programming Kit

If You have the T1 Series Control with an 8 Pin Data Port Plug, There is a Dedicated Kit For your Controller:
T1 Diagnostic and Programming Kit

If you have the 353E1 Controller Used on the Zenn Car
Zenn Car Diagnostic and Programming Kit

If you have the 262TB1 Controller Used on the Tomberlin NEV
Tomberlin EV Diagnostic and Programming Kit


PLEASE NOTE: Certain Parameters should not be changed from Factory Settings,
Forklift Electronics Is Not Responsible for any changes made to your existing settings.

Forklift Electronics
Home Index Page
2025